Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 91 / 280

TROUBLESHOOTING AND ELECTRICAL SYSTEM Test Procedures
11
TEST PROCEDURE 33 – Voltage Limiter (Vehicles with Headlights)
See General Warning on page 10-1.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section 10,
Page 10-2.
2. Remove the instrument panel. See Key Switch Removal on page 12-14.
3. Using a multimeter set on 20 volts DC, connect the red (+) probe to the light switch terminal with the yellow
wire
(Figure 11-50, Page 11-49) .
4. Loosen the black wire connector (on the end of the long black wire) at the voltage limiter just enough to maintain
the connection and yet expose part of the metal terminal in the connector. Place black (–) probe on the connector
(Figure 11-50, Page 11-49) . See following CAUTION.
CAUTION
• Before connecting battery cables, make sure no electrical components touch the front body trim
or other parts of the vehicle frame. Place a dry towel between the body trim and the center dash
to prevent an electrical short circuit.
5. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
6. Pull the light switch to the ON position. The reading should be 11-12 volts. If the there is no voltage reading,
check continuity of the 16-gauge black wire from the headlight to the voltage limiter. Check continuity of the
16-gauge black wire from voltage limiter to the ground terminal block. If the wires show continuity and the
readings are still incorrect, replace the voltage limiter.
See Voltage Limiter Removal, Section 12, Page 12-34.
7. With the Neutral Lockout switch in the MAINTENANCE position, start the engine and press the accelerator
pedal to the floor.
8. Push the light switch to the OFF position. The reading should be 14.7-15.3 volts.
9. Pull the light switch to the ON position. The reading should be 11-13 volts. If the reading does not drop from
14.5-15.5 volts to 11-13 volts, replace the voltage limiter.
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED
2
3
4
8
1
5 7
6
1. 20 VDC Setting 2. Light Switch 3. Blue Wire 4. Yellow Wire 5. Voltage Limiter 6. Black Wires 7. Ground Terminal Block 8. Frame Ground
1420
Figure 11-50 Voltage Limiter Circuit Test
2009 FE 350 Maintenance and Service Supplement Page 11-49