Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 152 / 280

13
Crankcase S10 FE 350 ENGINE
ENGINE REMOVAL
To perform repairs on crankcase components, remove engine from the vehicle. See following CAUTION.
CAUTION
• Before removal and disassembly, clean the engine.
1. Remove the powertrain. See Unitized Transaxle Removal on page 18-8. See following NOTE.
NOTE: The crankshaft has left-hand threads at the clutch mounting hole.
2. Remove starter/generator. See Starter/Generator Removal, Section 12, Page 12-1.
3. Remove drive clutch. See Drive Clutch Removal on page 19-4 and following NOTE.
4. Remove muffler. See Muffler Removal on page 17-1.
5. Remove engine mounting hardware (items 1, 2, 5 and 6) (Figure 13-4, Page 13-5) .
6. Lift engine from the mounting plate.
7. Remove crankcase oil drain plug and filler tube. Tip the engine slightly to allow all of the oil to drain from the
crankcase. Dispose of engine oil properly.
CRANKCASE COVER REMOVAL
1. Remove yellow jumper wire (11) from cord connector (12) (Figure 13-2, Page 13-4) .
2. Remove nuts and clamps at two-ended bolts (1 and 2) (Figure 13-3, Page 13-4) .
3. Remove eight bolts (3) and remove the crankcase cover (4). See following NOTE .
NOTE: If the crankcase cover sticks, tap lightly with a plastic mallet on alternate sides near the dowel pins (5) (Figure
13-3, Page 13-4) .
4. Remove the crankcase cover gasket completely. It may stick to the flanged surface of the crankcase.
11
12
3
4
1
2
5
5
526
Figure 13-2 Oil Level Sensor Wire
527
Figure 13-3 Crankcase Cover
Page 13-4 2009 FE 350 Maintenance and Service Supplement