Club Car FE 350, Дополнение к руководству по обслуживанию и ремонту

Страница: 171 / 280

S27 FE 350 ENGINE Engine Installation
14
type of oil. This engine should be regarded as a new engine for next scheduled oil change. See Periodic
Maintenance on page 10-1.
8. Check all hardware for proper torque/tightness.
9. Check engine oil level.
9.1. With vehicle on level surface, remove dip stick and clean with cloth (Figure 14-14, Page 14-11) .
9.2. Reinsert dip stick until fully seated.
9.3. Oil must be in the SAFE LEVEL range.
CAUTION
• Do not overfill with oil.
1
3
2
1.Full level 2. Safe level 3. Low level.
23
Figure 14-14 Check Engine Oil Level
10. Install a new or cleaned spark plug gapped to 0.027-0.031 inch (0.69-0.79 mm).
11. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 10, Page
10-3.
12. Adjust the engine RPM setting. See Engine RPM Adjustment on page 16-11.
13. Test-drive vehicle to ensure all systems are functional and correctly adjusted.
TORQUE SPECIFICATIONS
ITEM SIZE LIMITS
Flywheel retaining nut M16 63 ft-lb (86 N·m)
Crankcase cover to block bolts M8 250 in-lb (28.3 N·m)
Starter/Generator bracket to block bolts M8 200 in-lb (23 N·m)
Oil drain plug M14 20 ft-lb (27.1 N·m)
Fan housing screws M6 90 in-lb (10 N·m)
Fan shroud screws M6 25 in-lb (2.8 N·m)
Bolts marked with “4” (when used with nuts)
M8
M6
M5
130 in-lb (15 N·m)
50 in-lb (5.9 N·m)
30 in-lb (3.4 N·m)
2009 FE 350 Maintenance and Service Supplement Page 14-11