Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 423 / 456

CLUTCHES: GASOLINE VEHICLES Drive Clutch
25
2
3
4
1
602
Figure 25-10 Primary and Secondary Weights, Wave
Washer and Pin
6. Remove the retaining ring (6) from the shaft of the fixed sheave (18) and slide the moveable sheave (13) off the
shaft
(Figure 25-3, Page 25-4) . See following NOTE.
NOTE: If the moveable sheave is removed from the hub of the fixed sheave, the spiral back-up rings (11) must be
replaced with new rings (Figure 25-3, Page 25-4) .
7. Remove the spacer (14) and spring (15) (Figure 25-3, Page 25-4) .
8. Use a scribe or small pick to remove the spiral backup rings (11) from each end of the bore in the fixed sheave
(Figure 25-3, Page 25-4) . See also Figure 25-11, Page 25-9. Discard the rings.
605
Figure 25-11 Spiral Back-up Rings
INSPECTION OF DRIVE CLUTCH PARTS
1. Inspect the idler spacer (17) for smoothness (Figure 25-3, Page 25-4) .
2. Inspect the bore of the moveable sheave (13) for scarring or wear. The moveable sheave must be replaced if the
bore is worn to a diameter of 0.883 in. (22.4 mm) or larger
(Figure 25-3, Page 25-4) .
3. Inspect the steel shaft on the fixed sheave (18). There should be no measurable wear anywhere on the shaft.
Replace the shaft if it is worn, scratched, or damaged.
4. Inspect the thrust washer (9) for wear. If it is worn more than 0.030 in. (0.76 mm), turn it over or replace it with
a new one.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 25-9