Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 394 / 456

23
Engine Control Linkages FUEL SYSTEM: GASOLINE VEHICLES
CAUTION
• Inspect the limit switches inside the electrical component box. If a limit switch lever is bent, replace
the switch.
7°
2
1
3
3113
Figure 23-6 Accelerator Cable Cam Position – 7° (Top
View)
3043
Figure 23-7 Governor Cable At Throttle Body
7. Before tightening the jam nuts (3), set the park brake to the first latch and pawl position and check for proper
activation of switches.
8. While pressing the accelerator pedal, the following events should occur in exactly the order shown:
NOTE: Always perform a visual check to ensure the starter motor begins rotating the engine prior to the throttle
body lever moving.
_
EVENT APPROXIMATE PEDAL TRAVEL
Park brake release 0° to 4°
Solenoid activation and engine start 4° to 15°
Throttle body actuation 15° and greater
9. While holding the accelerator ball joint with pliers, tighten the jam nuts against the ball joints, accelerator ball joint
first, at each end of the accelerator rod.
10. Check rod adjustment for proper switch activation.
11. After the pedal group and accelerator rod are properly adjusted, adjust the engine RPM setting. See Engine
RPM Adjustment on page 23-13.
12. Install the electrical component box cover and tighten retaining screw to 18 in·lb (2.0 N·m).
13. Connect battery and spark plug wire(s). See Connecting the Battery-Gasoline Vehicles on page 1-5.
Page 23-8 2017 Carryall 500 and 700 Maintenance and Service Manual