Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 71 / 456

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Gasoline Vehicles
5
0 to 5°
Top View of the Electrical Component Box
3016
Figure 5-18 Accelerator Cable
CAUTION
• After accelerator rod adjustment, make sure that approximately the same number of threads are
exposed at each end of the accelerator rod.
• If the lever on the limit switch in the electrical box is bent, replace the limit switch.
• When loosening jam nuts on the accelerator rod with one end disconnected, hold the disconnected
accelerator rod with locking pliers.
• When tightening jam nuts on the accelerator rod, hold the disconnected ball joint with locking pliers.
6.3. Reconnect the accelerator rod at the accelerator pedal.
6.4. Before tightening jam nuts on accelerator rod, set park brake to first ratchet and pawl position. Press
accelerator pedal and make sure the following events occur in the exact order shown:
_
EVENT APPROXIMATE PEDAL TRAVEL
Park brake release 2° to 4°
Solenoid activation 4° to 8°
Throttle body actuation 8° to 12°
6.5. If the events above occur as they should, hold the ball joint at each end of the accelerator rod with pliers
and tighten the accelerator rod jam nut against it.
6.6. Ensure that the events occur as described in the table above. See following NOTE.
NOTE: After the pedal group and accelerator rod are adjusted, the final governed engine RPM should be set. See
Engine RPM Adjustment, Section 23, Page 23-13.
6.7. Install the electrical box cover and screw.
7. Adjust the brakes. See Brake Adjustment, Section 6, Page 6-6.
8. Connect the battery cables. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 5-15