Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 205 / 456

ELECTRICAL SYSTEM TROUBLESHOOTING: IQ
PLUS ELECTRIC VEHICLES Test Procedures
12
1. With batteries connected, Run/Tow switch in the RUN position and the key switch in the OFF position, connect
charger DC cord to vehicle.
2. In a few seconds, the light will flash three times and the reverse buzzer simultaneously will sound three times to
indicate charging has begun.
See following NOTE.
NOTE: The number of flashes and beeps can vary depending on the Beep Option setting. See Beep Option,
Section 11, Page 11-9.
3. If charge indicator light does not flash three times, disconnect charger DC cord from vehicle and connect an
CDT to the vehicle.
4. Access the Monitor menu and select LED Driver by using the SCROLL DISPLAY buttons. The CDT should
indicate OFF.
5. Reconnect charger DC cord to vehicle.
6. In a few seconds, the CDT should quickly display ON just once while the dash-mounted charge indicator light
flashes three times.
See following NOTE.
NOTE: The CDT will still flash ON even with a failed or missing charge indicator light.
7. If the CDT quickly displays ON but the charge indicator light still does not flash, check the following items:
– Condition of the blue/yellow wire terminal in the 16-pin connector.
– Condition of the 9-pin connector behind instrument panel.
– Condition of the yellow/green wire terminal in the instrument panel wire harness.
– Continuity of the wires in the wire harnesses.
8. If no problems exist in the above items, replace the charge indicator light.
TEST PROCEDURE 19 – 4-Pin Connector (for Connected Car Device)
See General Warnings on page 1-1.
NOTE: This is a voltage and continuity test.
Pin 1 – Yellow/Black Pin 4 – White/Black
Pin 2 – Red/White Pin 3 – Open (No wire)
2786
Figure 12-21 4-Pin Connector
1. If necessary, see Testing Basics on page 12-14.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 12-43