Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 187 / 456

ELECTRICAL SYSTEM TROUBLESHOOTING: IQ
PLUS ELECTRIC VEHICLES Test Procedures
12
4.1. Access the Monitor menu and select REVERSE INPUT by using the SCROLL DISPLAY buttons. The CDT
should indicate OFF when the Forward/Reverse switch is in the NEUTRAL or FORWARD position.
4.2. Place the Forward/Reverse switch in the REVERSE position. The CDT should indicate that REVERSE
INPUT is ON. If the CDT indicates any other reading, check vehicle wiring. See Wiring Diagrams on page
12-4. . Also check the 24-pin connector at the speed controller. See 24-Pin Connector on page 12-33.
5. If the CDT displays readings other than those described above and the wiring is found to be correct, proceed to
the following procedure.
Forward/Reverse Rocker Switch Test without the CDT Handset
1. If necessary, see Testing Basics on page 12-14.
2. Place the Run/Tow switch in the RUN position and the Forward/Reverse switch in the NEUTRAL position.
3. Remove Forward/Reverse switch from its housing by carefully prying up each side with a small, flat-tip screwdriver.
4. Back-probe the following three wires connected to the Forward/Reverse switch in each position:
4.1. Orange Wire
– The orange wire provides power to the switch and should show BPV coming to the switch in all three
positions.
If the orange wire does not show BPV, check the 15-amp fuse, Run/Tow switch, red-to-pink wire spade
terminal connection and related wiring.
4.2. Brown Wire
– The brown wire should show BPV in FORWARD.
– The brown wire should show zero (0) volts in NEUTRAL and REVERSE
If the brown wire shows voltage in NEUTRAL, the switch may have corrosion across the contacts or the
switch has failed CLOSED and must be replaced.
See Forward/Reverse Rocker Switch Removal on
page 13-3.
If the brown wire does not show BPV in FORWARD, the switch may have corrosion on the contact or the
switch has failed OPEN and must be replaced.
See Forward/Reverse Rocker Switch Removal on
page 13-3.
4.3. Red/Green Wire
– The red/green wire should show BPV in REVERSE.
– The red/green wire should show zero (0) volts in NEUTRAL and FORWARD.
If the red/green wire shows voltage in NEUTRAL, the switch may have corrosion across the contacts or the
switch has failed CLOSED and must be replaced.
See Forward/Reverse Rocker Switch Removal on
page 13-3.
If the red/green wire does not show BPV in REVERSE, the switch may have corrosion on the contact or
the switch has failed OPEN and must be replaced.
See Forward/Reverse Rocker Switch Removal on
page 13-3. .
5. When installing the Forward/Reverse switch into its housing, orient the three wire terminals towards the front of
the vehicle (i.e. biased closer to the front of the switch housing and farther from the rear body).
TEST PROCEDURE 9 – Solenoid Activating Coil
See General Warnings on page 1-1.
NOTE: This is a resistance test.
1. If necessary, see Testing Basics on page 12-14.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 12-25