Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 395 / 456

FUEL SYSTEM: GASOLINE VEHICLES Engine Control Linkages
23
GOVERNOR CABLE
Governor Cable Removal
1. Turn the key switch to the OFF position and remove the key, place the Forward/Reverse handle in the NEUTRAL
position, and chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting the Battery-Gasoline Vehicles on page 1-5.
3. At engine:
3.1. If equipped, remove air deflector from top of engine.
3.2. Disconnect “Z” fitting of governor cable (1) from throttle lever (2) (Figure 23-7, Page 23-8) .
3.3. Unsnap governor cable (1) from throttle body bracket (3).
4. At transaxle:
4.1. Disconnect “Z” fitting of governor cable (1) from governor arm (4) (Figure 23-8, Page 23-10) .
4.2. Loosen jam nuts at governor bracket (5) and remove cable (1) from vehicle.
Governor Cable Installation and Adjustment
1. At engine:
1.1. Snap governor cable (1) into throttle body bracket (3) (Figure 23-7, Page 23-8) .
1.2. Connect “Z” fitting of governor cable (1) to throttle lever (2).
1.3. If equipped, install air deflector on top of engine.
2. At transaxle:
2.1. Slide bellows off threaded end of cable housing, separate jam nuts and place threaded end into governor
bracket (5) (Figure 23-8, Page 23-10) .
2.2. Finger-tighten jam nuts.
2.3. Push bellows back onto threaded end of cable housing.
2.4. Connect “Z” fitting of governor cable (1) to governor arm (4).
3. Rotate governor arm (4) counterclockwise until it stops and hold in this position (Figure 23-9, Page 23-10) .
4. Adjust jam nuts until throttle lever (2) is at “wide open throttle” (WOT) (Figure 23-7, Page 23-8) . Then, tighten the
jam nuts to 36 in·lb (4.0 N·m).
5. Release governor arm (4) and loosen jam nut (6) on throttle stop screw (7) (Figure 23-9, Page 23-10) .
6. Adjust gap between governor arm (4) and throttle stop screw (7) to 0.055 in. (±0.039) (1.4 mm (±1)) as shown.
7. Tighten stop screw jam nut (6) to 36 in·lb (4.0 N·m).
8. Check engine RPM adjustment. See Engine RPM Adjustment on page 23-13.
2017 Carryall 500 and 700 Maintenance and Service Manual Page 23-9