TROUBLESHOOTING AND ELECTRICAL
SYSTEM: PEDAL-START GAS VEHICLE
Test Procedures
18
TEST PROCEDURE 3 – Ground Cables
See General Warnings on page 1-1.
NOTE:
This is a continuity test for the main ground wire(s) of the vehicle. An additional ground wire is located
on top of the fuel tank.
1.
If necessary, see Testing Basics on page 18-15.
2.
Disconnect battery and spark plug wire(s).
See Disconnecting the Battery-Gasoline Vehicles on page 1-5.
3.
Check the following wires and cables for clean, tight connections and continuity
– Check the starter/generator ground cable (black wire) from A1 terminal to chassis.
– Check the battery ground cable from the disconnected terminal to chassis.
– Check the engine ground cable from engine block to chassis.
4.
The reading should be continuity. If the reading is incorrect, clean and tighten cable connections. If the
connections are good and the reading is incorrect, repair or replace the wire or cable.
5
4
1
2
3
1. Battery Ground 2. Main Wire Harness Ground 3. Engine Ground Cable 4. Starter/Generator Ground (from A1 Terminal) 5. Voltage Regulator
Ground Wire (from electrical component box)
3023
Figure 18-8
Ground Wires and Cables
2017 Carryall 500 and 700 Maintenance and Service Manual
Page 18-21
Содержание Carryall 500
