Club Car Carryall 500, Руководство по техническому обслуживанию и ремонту

Страница: 421 / 456

CLUTCHES: GASOLINE VEHICLES Drive Clutch
25
DRIVE CLUTCH DISASSEMBLY
CAUTION
• The drive clutch is balanced as an assembly. Before disassembly, make match marks on the drive
clutch hub and on the moveable sheave so they can be reassembled in the same positions (Figure
25-6, Page 25-7).
1. Make match marks on the drive clutch hub and on the moveable face (Figure 25-6, Page 25-7) .
2. Remove the drive clutch hub (5) (Figure 25-3, Page 25-4) :
2.1. Remove the three plugs (4) from the clutch puller attachment holes.
2.2. Thread the center bolt of the Drive Clutch Hub Puller (1) (CC P/N 1014497) into clutch until the stop nut
touches the clutch, then back the bolt out one-half turn (Figure 25-7, Page 25-7) .
2.3. Thread the three small bolts of the puller into corresponding holes in the clutch. Tighten bolts evenly,
making sure the face of the puller plate is parallel to the face of the clutch (Figure 25-7, Page 25-7) .
2.4. Unscrew the puller center bolt out of the clutch to pull drive clutch hub off.
(CCI P/N 1014497)
1
598
Figure 25-6 Mark Drive Clutch Hub
599
Figure 25-7 Remove Drive Clutch Hub
3. Remove the thrust washer (9) from the moveable sheave (13) (Figure 25-3, Page 25-4) .
4. Remove the drive buttons (3) by removing the screws (1), flat washers (2), and drive button take-up springs
(4) as shown
(Figure 25-8, Page 25-8) .
2017 Carryall 500 and 700 Maintenance and Service Manual Page 25-7