Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 373 / 536

UNITIZED TRANSAXLE: DASH-MOUNTED
SHIFTER Unitized Transaxle Installation
20
4. Position the transaxle mounting plate on the two mounting studs at the rear of the engine, and then install the two
mounting nuts finger tight
(Figure 20-36, Page 20-15) .
5. Install the remaining four mounting bolts and four nuts (one bolt and nut at each corner of the mounting plate)
finger tight.
6. Tighten the four corner nuts (with bolts) to 30 ft-lb (40.7 N·m). Tighten the two center nuts (on the engine block
studs) to 17 ft-lb (23.1 N·m)
(Figure 20-36, Page 20-15) .
7. Install the accelerator cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb (15.1 N·m)
(Figure 20-34, Page 20-14) .
585
Figure 20-36 Transaxle Mounting
586
Figure 20-37 Governor Arm
8. Install the governor cable bracket on transaxle case. Tighten the mounting screws to 134 in-lb (15.1 N·m)
(Figure 20-33, Page 20-14) .
9. Install governor lever arm on governor shaft (Figure 20-37, Page 20-15) .
9.1. With the governor lever arm loose on the governor shaft, turn the governor arm shaft counterclockwise
until it stops. Then pull the governor lever arm rearward until the carburetor throttle is in the “wide open
throttle” (WOT) position
(Figure 20-37, Page 20-15) .
9.2. While holding the arm and shaft in the fully counterclockwise position, tighten the governor arm lever nut to
35 in-lb (4.0 N·m) (Figure 20-37, Page 20-15) .
10. Install the key onto the input shaft (Figure 20-38, Page 20-16) .
11. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and mounting
bolt. Tighten the mounting bolt to 14 ft-lb (19.0 N·m) (Figure 20-38, Page 20-16) .
12. Install the drive belt. See Drive Belt Installation, Section 21, Page 21-3.
13. Remove the blocks from under the engine and roll the powertrain into position under the vehicle. Then lift the front
of the powertrain and place the snubber into the snubber bracket in the vehicle frame (Figure 20-39, Page 20-16) .
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 20-15