Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 59 / 536

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Electric Vehicles
5
00000
00000
00000
00000
0
PA
RK
ST
OP
GO
1 2
3
4
5
6
7
8
9
10
A
B
1
2
3
1. Locked Position
2. Ratchet (B) Tooth Length
3. Make sure pawl (A) engages at least 75% of ratchet tooth length (B).
Figure 5-24 Accelerator Pedal Height Measurement Figure 5-25 Ratchet/Pawl Tooth Engagement
3.5. With park brake still locked, measure the distance from the top of accelerator pedal to floorboard. If the
measurement has changed, ratchet tooth engagement is too deep and must be adjusted.
3.6. If ratchet/pawl engagement must be adjusted, disconnect the ball joint at the top of the brake rod and rotate
the ball joint sleeve clockwise to increase engagement or counterclockwise to decrease engagement.
Reconnect ball joint
(Figure 5-26, Page 5-17) .
3.7. Check for proper brake operation prior to driving the vehicle.
4. Adjust accelerator pedal height.
4.1. Loosen the nut and bolt (Figure 5-27, Page 5-17) securing the accelerator pedal to the pivot plate. Clamp
the accelerator pedal adjustment tool (CCI P/N 101871001) to the accelerator pedal, with the end marked
accelerator pedal height closest to the floorboard. Press the accelerator pedal until the end of the tool rests
against the floorboard; pedal height should be 5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in
position against the floorboard and then tighten nut to 26 ft-lb (35.3 N·m)
(Figure 5-28, Page 5-18) .
1
2
1. 1/2-Inch Socket
2. 1/2-Inch Wrench
Figure 5-26 Brake Rod Adjustment Figure 5-27 Accelerator Pedal Height Adjustment
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 5-17