Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 88 / 536

7
Rack and Pinion STEERING AND FRONT SUSPENSION
CAUTION
• In step 4, do not press against the outer race of the bearing.
4. If the bearing (9) was removed, press on a new bearing, exerting all pressure on the inner race (grease the bearing
before installing it). Then install the external snap ring (10)
(Figure 7-11, Page 7-9) . See preceding CAUTION.
5. If the needle bearing (7) is damaged, the steering box assembly (CCI P/N 101878302) must be replaced (Figure
7-11, Page 7-9) .
6. Install pinion (8) and bearing (9) assembly into the housing (6) (Figure 7-11, Page 7-9) . Make sure the rack gear
teeth will mesh with the gear teeth on the pinion. The rack may need to be rotated slightly while lightly tapping on
the pinion-bearing assembly with a rubber mallet.
See following CAUTION.
CAUTION
• Do not force the pinion-bearing assembly into the housing. The gear teeth or the small bearing
could be damaged.
1
2
16
15
Figure 7-12 Press In Dust Seal Figure 7-13 Rack and Pinion Adjustment
3
1
2
Figure 7-14 Rack and Pinion Resistance
7. Install the internal snap ring (11) (Figure 7-11, Page 7-9) .
8. Using an appropriate size deep well socket (1) to apply pressure evenly, press in a new dust seal (2) (Figure
7-12, Page 7-10) .
Page 7-10 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual