14
Starter/Generator
ELECTRICAL COMPONENTS: PEDAL-
START GAS VEHICLE
5
11
4
9
12
1
10
F2
DF
7
2
13
F1
14
A
A2
A1
486
Figure 14-1
Starter/Generator Removal
DISASSEMBLY OF THE STARTER/GENERATOR TO SERVICE THE BRUSHES
1.
Remove the two bolts (20) and pull commutator end cover (23) free of starter/generator housing (24)
See following NOTE.
NOTE:
If the brushes are not removed, contact between the brushes and commutator as the commutator end cover is
being removed or installed could damage the brushes. Lift the brush springs out of the notches in the brushes
and pull the brushes back from the center of the commutator end cover. The springs will rest on the sides of
the brushes and help prevent them from sliding towards the center of the cover
2.
Remove brush covers (29 and 30), screws (25) and lock washers (26), brush springs (28), and brushes (27)
See following NOTE.
NOTE:
To clean and inspect the armature/commutator and the bearings, see
Disassembly of the Starter/Generator
to Service the Armature/Commutator on page 14-4
20
23
24
26
27
29
23
25
30
28
487
Figure 14-2
Commutator End Cover
488
Figure 14-3
Brush Covers and Brushes
BRUSH INSPECTION AND REPLACEMENT
1.
Visually inspect brushes. Replace brushes that are cracked or severely chipped.
Page 14-2
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Содержание CARRYALL 252 2007
