Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 340 / 536

18
Engine Control Linkage S27 FE 350 FUEL SYSTEM
Accelerator Cable Installation
1. Connect the cable to the cam (17) in the electrical box (Figure 18-9, Page 18-9) .
2. Insert the cable housing into the mounting slot in the wall of the electrical box, with approximately the same
number of threads visible between the jam nuts as are visible from the nut inside the box to the end of the cable
housing
(Figure 18-7, Page 18-7) . Tighten the nuts finger-tight.
3. Connect the spring (16) to the engine governor arm (Figure 18-9, Page 18-9) .
4. Install cable in accelerator cable bracket (5).
5. Push the cable dust shield onto the spring end of the cable conduit.
6. Before tightening the cable housing retaining nuts, make sure the engine RPM adjustment is correct. See
Engine RPM Adjustment on page 18-11.
7. Install the electrical box cover, and tighten the retaining screw to 18 in-lb (2.0 N·m).
8. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-3.
CLOSED THROTTLE OR IDLE ADJUSTMENT
Pedal-Start vehicles: When the accelerator pedal is released, the engine will stop. Therefore, it is not possible to
measure or set idling speed under normal vehicle operating conditions. Set throttle valve as follows:
1. Loosen the carburetor idle screw so that it is not touching the throttle lever (Figure 18-10, Page 18-10) .
2. Slowly tighten the idle screw until it lightly touches the throttle lever, then tighten it an additional 3/4 turn.
Key-Start vehicles: When the engine running and the Forward/Reverse control in NEUTRAL, attach a tachometer
(CCI P/N 1016112) to the spark plug wire and adjust the idle screw on the carburetor until the tachometer reads 1200
to 1250 RPM
(Figure 18-10, Page 18-10) .
543
Figure 18-10 Idle Screw
Page 18-10 2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual