ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group Adjustment – Gasoline Vehicles
5
3.8. Check for proper brake operation prior to driving the vehicle.
1
2
1. 1/2-Inch Socket
2. 1/2-Inch Wrench
Figure 5-15
Brake Rod Adjustment
Figure 5-16
Accelerator Pedal Height Adjustment
4.
Adjust accelerator pedal height.
4.1. Loosen the nut and bolt
securing the accelerator pedal to the pivot plate. Clamp
the accelerator pedal adjustment tool (CCI P/N 101871001) to the accelerator pedal, with the end marked
accelerator pedal height
closest to the floorboard. Press the accelerator pedal until the end of the tool rests
against the floorboard; pedal height should be 5-5/8 inches (14.3 cm). Use a rubber strap to hold pedal in
position against the floorboard and then tighten nut to 26 ft-lb (35.3 N·m)
000
000
000
0
ST
OP
PARK
GO
0
GO
0
ST
OP
PARK
MICRO BR
EAK POINT
MICRO BR
EAK POINT
1
2
1. Accelerator Pedal Adjustment Tool (CCI P/N 101871001)
2. Rubber Strap
Figure 5-17
Accelerator Pedal Height Adjustment
5.
Adjust the accelerator rod.
See following DANGER.
DANGER
• Before servicing, turn the key switch to the OFF position and place the Forward/Reverse handle in
the NEUTRAL position.
• To prevent accidentally starting the vehicle, disconnect the battery cables. See Disconnecting the
Battery – Gasoline Vehicles, Section 1, Page 1-3. This will prevent the possibility of the vehicle running
over you when you are adjusting the accelerator rod.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual
Page 5-13
Содержание CARRYALL 252 2007
