Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 57 / 536

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group Adjustment – Electric Vehicles
5
5.7. Install the electrical box cover and screw.
6. Adjust the brakes. See Brake Adjustment (Manually-Adjusted Brakes) on page 6-7.
PEDAL GROUP ADJUSTMENT – ELECTRIC VEHICLES
See General Warning on page 1-1.
1. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles,
Section 1, Page 1-4.
2. Adjust brake pedal height.
2.1. Chock wheels and release park brake. Lift rear of vehicle and place jack stands under the axle tubes
to support the vehicle.
2.2. To provide slack in the brake cables, loosen the equalizer retaining nuts (2 and 3) on the equalizer rod
(1) (Figure 5-19, Page 5-15) .
2.3. Four-wheel brake vehicles only: Loosen the front brake equalizer rod (Figure 5-20, Page 5-15) .
1
3
2
4
2
Figure 5-19 Loosen Rear Brake Equalizer Rod Nuts Figure 5-20 Loosen Front Brake Equalizer Rod Nuts
2.4. Loosen the brake stop jam nut (31), then relieve pedal pressure on the stop by pushing down slightly on
the pedal. Next, adjust the brake stop bumper (22) up or down (Figure 5-21, Page 5-16) . Adjusting the
bumper upward decreases distance between pedal and floorboard. Adjusting the bumper downward
increases distance between pedal and floorboard. Proper brake pedal height is 6 inches (15.2 cm)
(Figure
5-22, Page 5-16) .
2.5. Tighten the jam nut (31) to 8 ft-lb (9.5 N·m) (Figure 5-21, Page 5-16) .
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 5-15