Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту, Страница: 77 / 536

WHEEL BRAKE ASSEMBLIES Rear Brake Cables
6
4. Route cable along I-beam towards front of the vehicle and secure as shown (Figure 6-23, Page 6-17) .
NOTE: 77.5 in. (196.9 cm) and 78.5 in. (199.4 cm) wheelbase electric vehicles: Route cable through hole in
I-beam crossmember.
5. Route brake cable between the shock support (8) and brake cable guide bracket (7) (Figure 6-21, Page 6-15) .
Secure brake cable retainer clips (5) with a bolt (4) and nut (6).
6. Install brake cable through the front spindle brackets and install E-clip (1).
7. Install brake cable clevis onto brake lever arm and install clevis pin (3) and a new bow-tie pin (2).
8. Adjust brakes as described in this section for the appropriate vehicle.
2
7
3
Figure 6-23 Front Brake Cable Routing
REAR BRAKE CABLES
See General Warning on page 1-1. See also Warning, on Page 6-1.
REAR BRAKE CABLE REMOVAL
1. Chock wheels to keep vehicle from unintentionally moving.
2. Release park brake if latched and loosen equalizer retaining nuts (1) on equalizer rod (2) to slightly loosen
brake cables (3)
(Figure 6-24, Page 6-18) .
3. Rotate brake cables upward and pull ends through holes in top of equalizer.
4. Disconnect brake cables at rear wheels.
4.1. Remove bow-tie pins (1), clevis pins (2), and E-clips (3) (Figure 6-25, Page 6-18) .
4.2. Remove cable (4) from cable support bracket (5).
4.3. Note location of hangers (for installation of cables). Pull cables out of vehicle.
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 6-17