Club Car CARRYALL 252 2007, Руководство по техническому обслуживанию и ремонту

Страница: 337 / 536

S27 FE 350 FUEL SYSTEM Engine Control Linkage
18
Accelerator Rod Installation and Adjustment
1. Before installing the accelerator rod, adjust accelerator pedal position. See Accelerator and Brake Pedal Group
Section in the appropriate maintenance and service manual.
2. Install the ball joint on the ball stud at the accelerator pedal (Figure 18-6, Page 18-6) .
3. Access the engine compartment.
4. Remove the electrical box screw and cover (Figure 18-7, Page 18-7) .
5. Adjust length of accelerator rod. With the ball joint jam nuts (3) loose (Figure 18-6, Page 18-6) , adjust the
length of the accelerator rod so the indicated cam edge is parallel with the electrical component box as shown
(Figure 18-7, Page 18-7) . See following CAUTION.
CAUTION
• Be sure that approximately an equal number of threads are exposed at each end of the accelerator rod.
6. Install the accelerator rod on the bell crank ball joint on the electrical component box (Figure 18-8, Page 18-7) .
See following CAUTION and NOTE.
CAUTION
• Inspect the limit switch inside the electrical box. If the limit switch lever is bent, replace the switch.
NOTE: Use the inside hole location, or hole closest to the bell crank shaft as shown (Figure 18-8, Page 18-7) .
3
540
Figure 18-7 Cam Position – Parallel with Box (Top View)
541
Figure 18-8 Accelerator Rod – Pull Spring Release to
Attach (Bottom View)
7. Before tightening the jam nuts, set the park brake to the first latch and pawl position and check for proper
activation of switches.
8. While pressing the accelerator pedal, the following events should occur in exactly the order shown:
EVENT APPROXIMATE PEDAL TRAVEL
Park brake release 0°-4°
Solenoid activation 4°-8°
Carburetor throttle actuation 8°-12°
2007-2009 Turf 252, Carryall 252 and XRT 900 Maintenance and Service Manual Page 18-7