NOTE:
Verify that nothing on the ground will damage the
cover when it is unrolled.
2. Roll opposite edges evenly to the center.
3. Next, roll the ends of the cover toward the center.
When rolled properly, the cover will appear as shown.
4. With lifts and assistance, raise the rolled cover into
position on the frame and inline with a rafter.
NOTE:
Place a section of cardboard on the frame at the
peak if desired to set the rolled cover on.
5. Align the cover with a rafter. See photo below. Once
it is placed at the top of the frame, unroll the cover
along the rafter in both directions.
6. With the cover in position on the frame, move to a lift
on the inside of the frame and unroll the cover along
the rafter as shown below.
Cover is rolled to its end in the direction of one double
arrow and then opened in the direction of the remaining
double arrow.
7. As the cover is unrolled in the final two directions,
temporarily secure the cover to the rafters using the
straps at the top and at the mid locations. Straps are
Top/outside is up.
Hole in Cover
Rolled Cover
Cardboard
Cover is set
on the crown.
Visit www.ClearSpan.com for additional products and customer assistance.
20 of 36
