14-28
Cisco SCE 8000 10GBE Software Configuration Guide
OL-30621-02
Chapter 14 Value-Added Services (VAS) Traffic Forwarding
Configuring VAS Traffic Forwarding
Options
The following options are available:
•
ip-address
—IP address to be used (any IP address as long as it is not possible to be found in the
network traffic, such as a private IP)
–
Default—no IP address
•
mask
(optional)—Defines the range of IP addresses that can be used by the Cisco SCE platform.
Note that the Cisco SCE platform is not required to reside in this subnet.
–
Default—255.255.255.255 (The subnet mask can be set to 255.255.255.255, as the health check
mechanism requires only one IP address per interface.)
How to Define the Pseudo IP Address
Use this command to define the pseudo IP address to be used for the health check.
From the SCE(config if)#>prompt, type:
How to Delete the Pseudo IP Address
From the SCE(config if)#>prompt, type:
Configuring a VAS Server Group
You may define up to eight VAS server groups. Each VAS server group has the following parameters:
•
Server Group ID
•
A list of VAS servers attached to this group.
•
Failure detection—minimum number of active servers required for this group so it will be
considered to be Active. If the number of active servers goes below this minimum, the group will be
in Failure state.
•
Failure action—action performed on all new data flows that should be mapped to this Server Group
while it is in Failure state.
Options:
–
block
–
pass
You can perform these operations for a VAS server group:
•
Add a VAS server to or remove a VAS server from a specified group.
•
Configure the minimum number of active servers for a specified group.
•
Configure failure behavior for a specified group.
Command
Purpose
pseudo-ip
ip-address [mask]
Defines the pseudo IP address.
Command
Purpose
no pseudo-ip
ip-address [mask]
Deletes the pseudo IP address.