9-9
Cisco SCE 8000 10GBE Software Configuration Guide
OL-30621-02
Chapter 9 Raw Data Formatting: The RDR Formatter and NetFlow Exporting
Configuring Data Destinations and Categories
Configuring the Buffer Size
Options
The following options are available:
•
category-number
—the number of the category (1-4)
•
size
—the size of the buffer in bytes
By default, the buffer sizes are as follows:
–
Category 1—40 MB
–
Category 2—24 MB
–
Category 3—8 MB
–
Category 4—8 MB
Total buffer size is 80 MB.
From the SCE(config)# prompt, type:
Configuring a Destination and Assigning Categories
Options
The following options are available:
•
ip-address—
The IP address of the destination
•
portnumber—
The port number
•
category-number—
The number of the category (1-4)
•
category-name—
The name to be assigned to the category
•
priority—
The priority value assigned to this category for this destination (1-100)
•
protocol—
The protocol used for data sent to the destination (either RDRv1 or NetFlow; if no
protocol is assigned the protocol is RdrV1)
•
transport—
The transport type, TCP or UDP (optional, as this parameter is determined by the
protocol)
General Guidelines:
•
A maximum of four categories can be configured in one command.
•
The category may defined by either number or name.
•
A different priority may be assigned to each category.
•
Note that within each category the priorities must be unique for each destination.
Command
Purpose
rdr-formatter category number
category-number
buffer-size
size
Configures the buffer size for the specified
category number.
