Cisco DPA 7610, Руководство администратора

Страница: 78 / 188

Chapter 4 Preparing the Cisco CallManager and Octel Systems
Configuring Cisco CallManager
4-2
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
78-11069-03
information from both the Cisco CallManager and Octel systems. Refer to
Table 4-1 for an overview of the tasks and information you need from them to
configure the DPA 7630/7610.
Configuring Cisco CallManager
The DPA requires minor changes to Cisco CallManager because when you add
the DPA 7630/7610 to the IP network, Cisco CallManager recognizes the ports as
Cisco IP Phones. Therefore, you need to add these ports to the Cisco CallManager
database. Additionally, because of the close interaction of the DPA 7630/7610
with the voice mail system, you must ensure that some key voice mail settings on
the Cisco CallManager system are properly configured.
Table 4-1 System Setup Checklist
Task For More Information
Cisco CallManager Configuration
Add the DPA 7630/7610 to the
Cisco CallManager database. See “Adding the DPA 7630/7610 to
Cisco CallManager” section on page 4-3 .
Verify that the voice mail hunt group is set up
properly. See “Setting Up the Voice Mail Hunt Group”
section on page 4-5
Configure the ports from the DPA 7630/7610
as Cisco IP Phones in Cisco CallManager. See “Configuring the DPA Ports and Phones”
section on page 4-10 .
Verify that the options for enabling and
disabling MWI on the Cisco IP Phones are
configured in Cisco CallManager. See “Configuring the Message Waiting Light”
section on page 4-13 .
Octel Configuration
Set dialing sequence for message waiting
indicator. See the “Setting Dialing Sequence for Message
Waiting Indicator” section on page 4-15 .
Determine incoming call method. See the “Determining Incoming Call Mode”
section on page 4-15 .
Assign lines to handle incoming calls,
outgoing calls, and MWI commands. See the “Assigning Incoming, Outgoing, and
MWI Lines” section on page 4-16 .