![background image](http://html.mh-extra.com/html/cisco/dpa-7610/dpa-7610_administration-manual_64877074.webp)
Chapter 3
Installing the DPA 7630/7610
Verifying Installation
3-18
Cisco DPA 7630/7610 Voice Mail Gateways Administration Guide
78-11069-03
Verifying Installation
After you complete installation of the DPA 7630/7610 and have connected power
to it, connect a console terminal to observe its initial startup procedure. You can
only observe these initial startup messages when connected to the console port.
Initially, the device uses DHCP by default, but you can reconfigure this after
startup.
The startup process proceeds as follows:
1.
Loads boot loader software image and starts up the DPA 7630/7610.
2.
Performs self tests on the hardware, indicating whether the component
passed; for example:
Testing RAM......passed
Testing FLASH....passed
Testing EEPROM...passed
Testing Ethernet..passed
3.
Pauses for 10 seconds, allowing you to access the boot loader by pressing the
Esc key on the console terminal. The boot loader allows you to do the
following:
•
Load a software image using FTP, allowing recovery from a previous
failed upgrade (see
“Resolving an Incomplete Upgrade” section on
page 7-4
).
•
Load an image using XMODEM
•
Reset to factory default settings
4.
Loads the main software image and displays the main menu (see
Figure 3-13
).
Содержание DPA 7610
Страница 4: ......
Страница 12: ...Contents xii Cisco DPA 7630 7610 Voice Mail Gateways Administration Guide 78 11069 03 ...