3-30
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-03
Chapter 3 Getting Started with CMS
Accessing CMS
Accessing CMS
This section assumes the following:
•
You know the IP address and password of the command switch or a specific switch. This information
is either:
–
Assigned to the switch by following the setup program, as described in the release notes.
–
Changed on the switch by following the information in the
“Assigning Switch Information”
section on page 4-2
and
“Preventing Unauthorized Access to Your Switch” section on page 6-1
.
Considerations for assigning IP addresses and passwords to a command switch and cluster
members are described in the
“IP Addresses” section on page 5-15
and
“Passwords” section on
page 5-16
.
•
You know your access privilege level to the switch.
•
You have referred to the release notes for system requirements and have followed the procedures for
installing the required Java plug-ins and configuring your browser.
Caution
Copies of the CMS pages you display are saved in your browser memory cache until you exit the
browser session. A password is not required to redisplay these pages, including the Cisco Systems
Access page. You can access the CLI by clicking Monitor the router - HTML access to the
command line interface from a cached copy of the Cisco Systems Access page. To prevent
unauthorized access to CMS and the CLI, exit your browser to end the browser session.
To access CMS, follow these steps:
Step 1
Enter the switch IP address and your privilege level in the browser Location field (Netscape
Communicator) or Address field (Microsoft Internet Explorer). For example:
http://10.1.126.45:184/level/14/
where
10.1.126.45
is the switch IP address,
184
is the HTTP port, and level
14
is the privilege level.
You do not need to enter the HTTP port if the switch is using HTTP port 80 (the default) or enter the
privilege level if you have read-write access to the switch (privilege level is 15). For information about
the HTTP port, see the
“HTTP Access to CMS” section on page 3-31
. For information about privilege
levels, see the
“Access Modes in CMS” section on page 3-31
.
Step 2
When prompted for a username and password, enter only the switch enable password. CMS prompts you
a second time for a username and password. Enter only the enable password again.
If you configure a local username and password, make sure you enable it by using the ip http
authentication global configuration command. Enter your username and password when prompted.
Step 3
Click Web Console.
If you access CMS from a standalone or member switch, Device Manager appears. If you access CMS
from a command switch, you can display the Front Panel and Topology views.
