19-14
Catalyst 3550 Multilayer Switch Software Configuration Guide
78-11194-03
Chapter 19 Configuring Network Security with ACLs
Configuring Router ACLs
Creating Named Standard and Extended ACLs
You can identify IP ACLs with an alphanumeric string (a name) rather than a number. You can use named
ACLs to configure more IP access lists in a router than if you were to use numbered access lists. If you
identify your access list with a name rather than a number, the mode and command syntax are slightly
different. However, not all commands that use IP access lists accept a named access list.
Note
The name you give to a standard or extended ACL can also be a number in the supported range of
access list numbers. That is, the name of a standard IP ACL can be 1 to 99; the name of an extended
IP ACL can be 100 to 199. The advantage of using named ACLs instead of numbered lists is that you
can delete individual entries from a named list.
Consider these guidelines and limitations before configuring named ACLs:
•
Not all commands that accept a numbered ACL accept a named ACL. ACLs for packet filters and
route filters on interfaces can use a name. VLAN maps also accept a name.
•
A standard ACL and an extended ACL cannot have the same name.
•
Numbered ACLs are also available, as described in the
“Creating Standard and Extended IP ACLs”
section on page 19-6
.
•
You can apply standard and extended ACLs (named or numbered) to VLAN maps.
Beginning in privileged EXEC mode, follow these steps to create a standard ACL using names:
To remove a named standard ACL, use the no ip access-list standard name global configuration
command.
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ip access-list standard name
Define a standard IP access list using a name, and enter access-list
configuration mode.
Note
The name can be a number from 1 to 99.
Step 3
deny {source [source-wildcard] | host source |
any} [log]
or
permit {source [source-wildcard] | host source
| any} [log]
In access-list configuration mode, specify one or more conditions
denied or permitted to determine if the packet is forwarded or
dropped.
•
host source—A source and source wildcard of source 0.0.0.0.
•
any—A source and source wildcard of 0.0.0.0
255.255.255.255.
Step 4
end
Return to privileged EXEC mode.
Step 5
show access-lists [number | name]
Show the access list configuration.
Step 6
copy running-config startup-config
(Optional) Save your entries in the configuration file.
