Cisco 7246 - uBR Router, Руководство по установке оборудования

Страница: 49 / 238

2-3
Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide
OL-5421-03
Chapter 2 Preparing the Cisco uBR7200 Series Router for Installation
Safety Recommendations
•
Lift the chassis from the bottom; grasp the underside of the chassis exterior with both hands.
Figure 2-1 Lifting the Chassis (Cisco uBR7246 Shown)
Warning
Two people are required to lift the chassis. Grasp the chassis underneath the lower edge and lift with
both hands. To prevent injury, keep your back straight and lift with your legs, not your back. To prevent
damage to the chassis and components, never attempt to lift the chassis with the handles on the
power supplies or on the interface processors, or by the plastic panels on the front of the chassis.
These handles were not designed to support the weight of the chassis.
Statement 5
Safety with Electricity
Follow these basic guidelines when working with any electrical equipment:
•
Before beginning any procedures requiring access to the chassis interior, locate the emergency
power-off switch for the room in which you are working.
• Carefully examine your work area for possible hazards such as moist floors, ungrounded power
extension cables, and missing safety grounds.
•
Disconnect all power and external cables before installing or removing a chassis.
• Never assume that power has been disconnected from a circuit; always check.
•
Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
• Do not work alone if potentially hazardous conditions exist.
•
Never install equipment that appears damaged.
Caution You must power down the system before removing or replacing the I/O controller, cable clock card, or
network processing engine. The port adapters, cable interface line cards, and redundant power supplies
are designed to be removed and replaced while the system is operating, without presenting an electrical
hazard or damage to the system.
H10072