CIM MDM 1000, Руководство оператора

Страница: 36 / 100

5-36 METAL DOT MATRIX REV. 04.2002
5 HOW TO PRODUCE ONE CARD
OPERATORS MANUAL
1
2
1
Fig. 5.3
4
5
5
Fig. 5.4
Fig. 5.5
5.1.1.3 UNLOADER LIFT ADJUSTEMENT
To adjust the unloading support refer to
figure 5.3 and follow the instructions below:
•
Open the front cover.
•
Loosen the knob on the bottom of the
support (4).
•
Place the plate on the spring support.
•
Shift the right support towards the plate
until there is a gap of about 1 mm
•
Tighten the knobs .
•
Loosen the knobs (5) and repeat the
process mentioned in the Loader
section.
5.1.1.4 UNLOADER EJECTOR
ADJUSTEMENT
In the machines with unloading ejectors
(fig. 5.4) there is only one adjustment:
•
Loosen the black knob (1) [cilindric
nut UNI 5723-67/4A]
•
Place a plate on the ejector plane.
•
Shift the bracket towards the plate.
Leave a gap of a few millimeters
between the two.
•
Tighten the black knob.
5.1.2 MANUAL (1000) VERSION
5.1.2.1 LOADER/UNLOADER ADJUSTMENT
To adjust the loading/unloading (fig. 5.5)
do as follows:
•
Open the front cover.
•
Loosen the black knob on the rig ht
side of the loader (1) and slide it closer
to the plate to be embossed leaving a
tolerance of about 1mm and then
tighten the knob.
• Loosen the knobs of the reart support
(2).
•
Bring the rear support to a distance of
about 5mm from the plate and tighten
the knobs.
REV. 05-2008