CIM MDM 1000, Руководство оператора

Страница: 35 / 100

5-35
METAL DOT MATRIX REV. 04.2002
HOW TO PRODUCE ONE CARD 5
OPERATORS MANUAL
Fig. 5.2
1 2
3
5.1.1 AUTOMATIC (2000) VERSION
5.1.1.1 LOADER ADJUSTEMENT
The Loader unit for the metallic plates (fig.
5.2) is located on the rig ht side of the
Stamper and can be adjusted to the
dimensions of the plates.
To adjust the Loader do as follows:
• Open the front cover.
•
Loosen the black knobs (1) on the right
side of the Loader.
•
Bring the right support closer to the
plate to be embossed leaving a
tolerance of about 1 mm and then
tighten the knobs.
•
Loosen the wings knobs (1) of the rear
supports (2), slide them to a distance
of about 5 mm from the plate and
tighten the knobs.
•
Loosen the four knobs (3) to adjust the
plate thickness, pull the plate towards
the outside, set the supports 0.5 mm
higher and tighten the knobs.
5.1.1.2 UNLOADER ADJUSTEMENT
The Unloading unit is located on the left
side of the Stamper. There are two different
adjustment solutions depending the type
of plate and end use:
•
Unloader with Lift (5.1.1.3)
•
Unloader with Ejector (5.1.1.4)
The first permits a progressive stacking of
the plates inside the Metal Dot Matrix and
the second ejects the plates out of the
Stamper.
REV. 05-2008