CIM MDM 1000, Руководство оператора

Страница: 23 / 100

3-23
METAL DOT MATRIX REV. 04.2002
INSTALLATION 3
OPERATORS MANUAL
Fig. 3.3
1 3
7
6
2 4
5 8
3.2 ELECTRICAL CONNECTIONS
The installation of the METAL DOT MATRIX system
is easily done. Examine the rear control panel of
the cover, (Ref figure 3.3) there are all the sockets
for the various connections. Continue as follows:
- Connect the serial cable between the
Computer and the Stamper
- Connect the power supply cable to the PA 80
socket.
WARNING: TO AVOID ELECTRIC SHOCK
THE POWER CARD PROTECTIVE
GROUNDING CONDUCTOR MUST BE
CONNECTED TO A GROUND CIRCUIT
CONFORMS TO THE NATIONAL
STANDARD.
WARNING: REMEMBER TO CONNECT
THE SERIAL CABLE TO THE MACHINE
WHILE IT IS SWITCHED OFF TO AVOID
DAMAGING THE CIRCUITS.
1. MAIN SWITCH
2. FUSE
3. SOCKET PA80 FOR MAIN POWER SUPPLY
4. IDENTIFICATION PLATE
5. KEY SELECTOR (FOR TECHNICAL USE ONLY)
6. SOCKET TYPE 5 POLE DIN FOR KEYBOARD
7. SERIAL SOCKET FOR PC 25 PIN MALE
8. SERIAL SERVICE PORT
The CIM SpA cannot be held responsabile for the
consequences of not abiding by these principles
when using the machine thus in the case of
breadown please call the Technical Assistance.
3.3 CHOOSING THE WORKING PLACE
Install the machine at least 0,6 m of height. Take
care that the place where you install the machine
is conform to the environmental requirments of
cap. 1.8. Leave at least 0,3 m of distance from
each side of the machine and the closer wallsor
barriers in order to permits the better access to
connectors and the proper air conditioning. The
opening of the covers require 0,4 m freespace
also above the cover. Take care that the support
where you put the machine dosen't amplify the
noise level over the allow level (see cap. 1.8) and
that the work station's strenght is suitable to
support the machine (60 kg). Do not install the
machine on unstable surfaces.
REV. 05-2008