Chicago Dryer King Edge, Инструкция по эксплуатации

Страница: 26 / 290

Installation King Edge
2-12
2.3 Pre-Operational
Checkout
NOTE: For more information
within this manual about the
controls mentioned in the
following procedures, refer to
the OPERATING GUIDELINES
chapter, Operating Controls
section and to the CHI PANEL
OPERATION bulletin.
The unit requires a thorough checkout before it
can be placed into full operation. This includes:
Final Protective Wrapper Removal
Security of Hardware
Clean the Corner Photosensors
Compressed Air Supply Checkout
Safety Device/CHI Panel Function
Checkout
Spread/Feed Function Checkout
Checkout Completion
Cleaning the Unit
WARNING
Do not put the unit into
service until all controls
are functioning properly.
Failure to do so may result in
serious injury to operators or
maintenance personnel.
Final Protective Wrapper Removal
Remove any and all remaining protective
wrapping or packaging. Remove the protective
plastic covers from the controls.
•
•
•
•
•
•
•
•
Security of Hardware
Hardware may loosen during shipment or
rigging.
Make sure power is OFF at the main dis-
connect switch.
Open both endframe doors.
The upper spreader encoder is located
in the left endframe (Figure 2-22). It is
mounted on a bracket very close to the
teeth of the sprocket.
Make sure that the encoder does not touch
the teeth of the sprocket - it should be .04”
(1 mm) from the teeth.
Check all hardware connections and
tighten as necessary.
Check that all setscrews are sufficiently
tightened to hold their respective compo-
nents in position.
Close and secure both endframe doors.
Make a final check that all protective
wrappers and packaging have been re-
moved.
CAUTION
Do not attempt to START the
machine at this time.
1.
2.
3.
4.
5.
6.
7.
8.
Figure 2-22: The upper spreader encoder in the left
endframe.