Chicago Dryer King Edge, Инструкция по эксплуатации

Страница: 176 / 290

Repair King Edge
7-54
Remove the black plastic cap which covers
the inner and outer band retaining screws
(Figure 76).
Remove the outer band retaining screw
(Figure 77). Be careful not to remove the
inner band screw which is right next to
the end cap.
CAUTION
Make sure all tools used
are clean. Dirt or debris
contaminating the inside of
the air cylinder can damage
or ruin it.
Be careful not to bend the
rodless air cylinder outer
band back too far. If the
band becomes creased or
deformed, it must
be replaced.
Hold back the outer band (Figure 78, A).
Be careful not to pull it back too far.
Use a clean Allen wrench or similar tool
to gently press against the inner band
(Figure 78, B). There should be very little
flexing.
6.
7.
8.
9.
Figure 76: A black plastic cover is located at each
end of the air cylinder.
Figure 78: When gently pressed, there should be
very little give in the inner band.
A
B
Figure 77: Remove the outer band retaining screw
to gain access to the inner band.