Chicago Dryer King Edge, Инструкция по эксплуатации

Страница: 138 / 290

Repair King Edge
7-16
Spreader Clamp Mechanical
Adjustment
Dropped flatwork during the spread operation
may indicate the spreader clamps are not properly
gripping the flatwork. The clamps can be adjusted
to tighten their hold.
NOTE: Adjustments can also be
made to the left spreader clamp
air pressure. For more information
within this chapter, refer to the
Compressed Air section, Left
Spreader Clamp Adjustment
procedure.
Required Tools
11/16”, 3/8” wrenches
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Loosen the jam nut (Figure 7-21).
Turn the cylinder rod for adjustment.
Once it is adjusted, retighten the jam
nut.
1.
2.
3.
4.
Upper Spreader Belt Tension
Adjustment
Adjust tension of the upper spreader belt when
it begins to sag noticeably or to skip on the timed
pulley. Both conditions cause excessive wear on
the belt and shorten its life.
Required Tools
9/16”, 3/8” wrenches
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Locate the upper spreader belt tension
adjustment bolts on the inner wall of the
upper left endframe (Figure 7-22, A).
Loosen the locknuts (Figure 7-22, B)
and turn each bolt the same number of
turns clockwise until the belt is properly
tensioned.
Tighten the locknuts to secure the adjust-
ment.
Start the unit and feed several pieces to
verify the adjustment.
Repeat Steps 1 to 5 until the adjustment
is satisfactory.
1.
2.
3.
4.
5.
6.
Figure 7-21: The spreader clamp air cylinder rod
and jam nut.
Figure 7-22: Upper spreader belt tension
adjustment bolts on the inside of the
left endframe.
A
B
A
B