Chattanooga Group OPTIFLEX3 2090, Руководство по обслуживанию

Страница: 27 / 48

25
OptiFlex® 3 Continuous Passive Motion (CPM) Therapy Unit
NOTE:
Cotter Pins are not supplied with the
replacement Acme Rod. Carefully remove
the Cotter Pin and retain for installation of
the Ball Screw. Refer to Figure 6.16.
11. Using Needle Nose pliers carefully remove the
Cotter Pin securing the Ball Screw to the front
end of the unit. Refer to Figure 6.16.
15. Pull out the Ball Screw.
16. Reverse for installation.
NOTE:
After installing the replacement Ball
Screw and prior to installing the Wipers,
coat the Screw with MolyGraph Grease
(Black) by Sta-Lube.
FIGURE 6.16
12. Remove the steel washer and the
bearing by using a Phillips screwdriver to
push the shaft of the Ball Screw through
the Front Plate.
NOTE:
Observe the locations of the washers and
bearings for installation. Insert A on page 38
details proper installation.
13. Slide the Carriage to the front end of the
Frame Base.
FIGURE 6.17
COTTER
PIN
SNAP RING
SNAP RING
HOUSING
14. Using Snap Ring pliers, remove the snap
ring inside of the Frame Base to release
the Ball Screw. Refer to Figure 6.17.
FIGURE 6.15
FEMUR
KNOBS
9. Remove both of the Wiper Blades by sliding
out of the open end of the Frame Base.
10. On the front end of the unit, loosen the
Femur Knobs and raise the Femur Bars to
full extension and tighten. Refer to
Figure 6.15.
6 REMOVAL & REPLACEMENT
6.8 ACME ROD (CONTINUED)