Heat Manager Pro User Manual V1.5 Page 63
3.8
A
LARM SETTINGS
(
FOR WELDER LIGHT
,
TEMPERATURE ALARMS
,
BURN-
ER HEAT DEMAND CONTROL
)
With the alarm settings, the event setvalues for a temperature deviation (in this case: event 4)
can be adjusted. When the Heatmanager Pro is fitted with an extra SRZ DIO (digital IO) module,
the status of the temperature deviation can be used to control the digital outputs of the relays of
the SRZ DIO module. This can be used for a welders light or a maximum temperature safety
signal.
For each separate segment and channel this alarm setvalue for event 4 can be set.
Please note that segment 8 is the so-
called “stop segment”. Only when a channel is set to
programmer, it will be in other segments than 8. So a slave, remote, or switched off channel, is
always in segment 8. Also when a programmer is set to stop status, its active segment will be
set to 8.
[CONFIG DIO]
Configure operation of DIO outputs (see engineering manual)
[ALARM CONFIG]
Configure event 4 function and operation (see engineering manual)
[BACK]
Go back to the previous screen
[CH 7-12]
Go to the settings for channel 7-12 (when present)
[MAIN MENU]
Return to the main menu
