Heat Manager Pro User Manual V1.5 Page 58
3.4
PV
OFFSET
(
ADJUST MEASURED TEMPERATURES
)
With this screen the measured temperatures can be adjusted. Use this screen with caution,
since normally those values must be set to 0. This screen is accessible with a password level
higher than or equal to 1.
Don’t forget to reset these values to 0 again after running a specific profile where this
setting was necessary. The next process can be started with incorrect temperatures
that can result in damage to the equipment, workpiece. It is also possible that an unsafe
situation can occur if the measured temperatures are not correct.
This screen shows the actual measured temperatures, including the PV offset. So when the PV
offset is set to 0, the PV shows exactly the same value as has been measured.
You can enter the offset by pushing on the yellow value to the right of the measured values, or
use the arrow up/down buttons for this. After correction, the PV will show the new value
including the new correction.
[RESET 1-6]
Reset all corrections back to 0 (no correction)
[BACK]
Go back to the previous screen
[MAIN MENU]
Go to the main menu
[CH 7-12]
Go to the screen for the correction of channels 7-12
