Heat Manager Pro User Manual V1.5 Page 20
2.3
E
DIT HEATING PROFILE
–
EASY MODE
When you set a channel to programmer and you push next, there are 2 ways of programming
the profile, in this section the so called
–easy mode- will be briefly discussed. This is the mode
that works with a ramp up+soak segment and a ramp down+end segment. When you need
more steps the Heatmanager Pro can be switched to the so-
called “normal mode” where up to 7
ramp+soak segments can be programmed.
Here you see a brief overview of the programmed profile.
The profile consists of:
-
Ramp up rate (or push the 1 button)
-
Soak temperature (or push the 2 button)
-
Soak time (or push the 3 button)
-
Ramp down rate (or push the 4 button)
-
End temperature (when the programmer/profiler reaches this value all channels will
continue controlling until the programmer channel is switched to stop mode by the
operator. (or push the 5 button).
You can change the set values by pushing the corresponding value on the screen (or by push-
ing the corresponding number next to it).
You can push the arrow up button /\ to advance the temperature set value in the first step freely
until 300°C (572°F). Above that temperature a ramp-up is mandatory and this button will
disappear.
When setting the ramp [degr/hour] to 0, the Heatmanager Pro immediately proceeds to the set
temperature without performing a ramp up/down.
By pushing [NEXT] you go to the next channel, by pushing [BACK] you return to the previous
screen (depending on the situation on how you entered this screen.)
