Carrier TruVu MPC, Руководство по установке и запуску

Страница: 53 / 67

To set up the controller through the Service Port
TruVu™ MPC Processor CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
49
Ports tab
IP Port
IP Addressing Select the type of addressing the controller is to use. See Addressing the TV-
MPCXP (page 16).
Port S1
End of Network Indicates status of the controller's End of Net? switch.
Active Protocol Indicates status of the controller's Port S1 Configuration rotary switch.
0=Disabled
1=MS/TP
2=ARCNET
3=Modbus
Address The address that is set on the three rotary switches. See To set the Port S1
address and baud rate (page 21).
Port S2
End of Network Indicates status of the controller's End of Net? switch.
Active Protocol The protocol that has been enabled for Port S2 on the BACnet or Modbus tab.
BACnet tab
IP Port
BACnet Network Number Disable Routing — Select if the IP port is not used.
Autogenerated — The BACnet/IP network number is automatically set to 1600.
Assigned — Lets you enter a specific number.
BACnet UDP Port The port that the i-Vu® application will use for BACnet communication.
Enable NAT Routing For future use.
Check if the TV-MPCXP is behind a NAT router (firewall).
Global NAT IP Address For future use.
Public IP address of the NAT router.
Global NAT BACnet UDP Port For future use.
Port number assigned to the NAT router's public interface.