Carrier TruVu MPC, Руководство по установке и запуску

Страница: 35 / 67

To communicate through the BACnet/IP Service Port network
TruVu™ MPC Processor CARRIER CORPORATION ©2021
Installation and Start-up Guide All rights reserved
31
You can connect to the Service Port to access your network through the:
•
i-Vu® application
•
Carrier touchscreen device
1
Connect an Ethernet cable from a computer to the controller as shown below.
2
Turn off the computer's Wi-Fi if it is on.
3
If your computer uses a static IP address, use the following settings:
○
Address: 169.254.1.x, where x is 2 to 7
○
Subnet Mask: 255.255.255.248
○
Default Gateway: 169.254.1.1
4
If it uses a DHCP address, leave the address as it is.
5
Open a web browser on the computer and login to your i-Vu® Pro application.
6
In the i-Vu® Pro interface, on the System Options tree, select Connections.
7
On the Properties page > Configure tab, Select BACnet/IP Service Port Connection from the drop-down list
and click Add .
8
If needed, enter the Service Port Network Number as follows:
○
0 - the TV- MPCXP will communicate only with the computer or TruVu™ ET Display
○
1 to 65534 - the TV-MPCXP's network number for network communication
○
65535 - searches for an available network number from 65531 to 65534. If any of these numbers are
not available, you will have to assign a network number and enter it.
9
Click Apply .
10
On the right of the page, in the Networks using selected connection table, click the checkbox next to the
network you want to connect to.
11
Click Apply .
12
Select the BACnet/IP Service Port Connection and click Start . The status changes to Connected .
13
Click Accept .
14
On the navigation tree, right-click the controller that you are connected to and select Module Status . If a
Modstat report appears, the i-Vu® application is communicating with the controller.
To communicate through the BACnet/IP Service Port network