Carrier Access Network Device Axxius 800, Руководство пользователя

Страница: 270 / 568

5-170 Axxius 800 - Release 2.2
CLI Commands
set
set (v35)
Use the set (v35) command to setup V.35 ports. The command specifies the range of channels
within that card, and the setting to apply.
Syntax:
set {v35-addr} {setting}
Example:
set 6:1 rxclk normal
To set port 1 (v.35) on slot 6 to no inversion on the receive clock
{v35-addr}
In the form of {slot:port}.
{setting}
Setting to apply one of the following:
slot Slot number (1-8) of the Axxius chassis where the V.35 card is located
port Port number or range.
clock Set the clock source to one of the following:
external to the external source
source to the internal Stratum 4E oscillator
cts Set the Clear To Send operation mode to one of the following:
cd follow CD
high force CTS high
low force CTS low
rts follow RTS
data Set the data mode to one of the following:
invert invert the receive and transmit data
normal do not invert receive and transmit data
equipment Sets the V.35 port to equipment loopback, which loops the transmit V.35
signal back toward the V.35 receive (toward the T1)
loopdown disable equipment loopback
loopup enable equipment loopback
line Sets the V.35 port to line loopback, which loops the received V.35 signal
back toward the V.35 signal toward the V.35 transmit (away from T1)
loopdown disable line loopback
loopup enable line loopback
rxclkinv Set the receive clock invert mode to one of the following:
invert invert the receive clock
normal do not invert the receive clock