Carrier Access Network Device Axxius 800, Руководство пользователя

Страница: 172 / 568

5-72 Axxius 800 - Release 2.2
CLI Commands
set
set (bri)
Use the set (bri) command to setup the ISDN BRI card.
Syntax:
set {bri-addr} {day|hour} {es|ses} {value}
Example:
set 3:4 threshold day ses 30
To set the daily threshold to 30 Severely Errored Seconds on port 4 of a BRI card
in slot 3.
{bri-addr}
The {slot:port} address of the BRI card you want to apply the changes to.
{setting}
crv
Set the Call Reference Value, when the BRI is set to 4:1 mode (lt4to1tdm). The CRV
value is between 1-768. Note: The CRV value for the BRI ports MUST be set the
same by both the Axxius 800 and the Access Navigator.
down
Take the ISDN line Out-of-Service.
threshold
Set the defect thresholds for ISDN lines to one of the following:
up
Put the ISDN line In-Service.
slot A for the controller card, or 1-8 for service cards.
port Port number or range.
day Set the thresholds for the daily intervals.
es Set the threshold for Errored Seconds (ES)
ses Set the threshold for Severely Errored Seconds (SES)
hour Set the thresholds for hourly intervals.
es Same as above
ses Same as above
value Range is 1 - 65535 seconds.