Canon iR3245, Руководство по обслуживанию

Страница: 111 / 746

Chapter 2
2-43
F-2-182
13) Insert the cable [1] into the terminal [2] of the voice board.
F-2-183
14) Remove the release paper of the cable guide [1] and install the cable
guide.
<Rear side - 3 location>
F-2-184
15) Route the cable [1] through the cable guide [2] and install the cable guide
cover [3].
F-2-185
16) Insert the power plug into the power outlet.
17) Turn on the main power switch.
18) Check to see that the voice board is recognized.
123 key (Counter Check key) > [Device Configuration]
When 'voice guidance' is displayed, the functions are enabled.
2.15.5 Checking the Settings
0019-9924
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
After turning on the power supply of the host machine, check the following
settings to use the voice guidance kit.
1) [Additional Function] > [Voice Navigation Settings] > [Voice Guide from
Speaker]
2) Check to see that it is ON.
3) If 'voice guidance kit' does not function normally, check the following
points.
The following item in service mode;
- COPIER > Display > VERSION
TTS-JA/TTS-EN has been correctly installed.
2.15.6 Operation Check
0019-9925
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
<To use>
1) Press the reset key for 3 sec or more.
2) Voice guidance kit becomes available to use if the copy count display
on the screen is framed in red.
<To stop>
1) Press the reset key for 3 sec or more.
2.16 Installing the Voice Operation Kit
2.16.1 Notice At Installation
0019-9928
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
2.16.2 Checking the Contents
0019-9929
iR3225 / iR3225N / iR3235 / iR3235N / iR3245 / iR3245N
<Voice Operation Kit-B1>
There should no excess slack on the cable.
[1] [2]
[3]
[1] [2]
[1]
See 'Combination Table of Accessories' when installing this equipment.
When the memory pre-installed on the host machine is less than 1GB,
install the additional memory Type A (512MB).
- When installing this equipment with the Expansion Bus, be sure to install
this equipment first.
- If the Expansion Bus has been installed, be sure to remove it and then
install this equipment.
[3]
[1] [2]