2
2
2-71
2-71
Process/Operation > Image Formation System > Controls > Waste Toner Feeding Area
Process/Operation > Image Formation System > Controls > Waste Toner Feeding Area
B: Varies according to the EXT-TBOX value
Service mode
setting value
Display timing of Waste Toner Container preparation warning
"0" (Default
setting)
When Waste Toner Full Sensor is turned ON
"1"
Below (1) or (2), whichever is earlier after the Waste Toner Full Sensor is ON.
(1) Count of the number of sheets: 1000 (1-sided: 1, 2-sided: 2, small size: 1, large
size: 2)
(2) Developing supply count: Supply amount equivalent to approx. 1000 counts at
5% image ratio
* This number of sheets decreases as the image ratio increases.
"2"
Below (1) or (2), whichever is earlier after the Waste Toner Full Sensor is ON.
(1) Count of the number of sheets: 2000 (1-sided: 1, 2-sided: 2, small size: 1, large
size: 2)
(2) Developing supply count: Supply amount equivalent to approx. 2000 counts at
5% image ratio
* This number of sheets decreases as the image ratio increases.
- - -
- - - -
Count of the number of sheets: Added in increments of 1000
Developing supply count: Added in increments of approx. 1000 sheets at 5%
image ratio
"9"
Below (1) or (2), whichever is earlier after the Waste Toner Full Sensor is ON.
(1) Count of the number of sheets: 9000 (1-sided: 1, 2-sided: 2, small size: 1, large
size: 2)
(2) Developing supply count: Supply amount equivalent to approx. 9000 counts at
5% image ratio
* This number of sheets decreases as the image ratio increases.
By using this service mode, the Waste Toner Container can be used effectively, but waste
toner may overflow depending on the environment or status of usage. Therefore, the value
must be set carefully. Following shows the reference for setting.
T-2-38
[A]
[B]
[C]
Line above label
Embossed line
Embossed line
When toner level in the Waste Toner Container at previous replacement is less than
A
+5
When toner level in the Waste Toner Container at previous replacement is over A
but less than B
+1
When toner level in the Waste Toner Container at previous replacement is over B
but less than C
Do not change
the value
When toner level in the Waste Toner Container at previous replacement is over C
-1
CAUTION:
Even setting the service mode as above, waste toner leak may occur depending
on usage of the user. (If a user prints a large volume of solid images in color, it may
overflows.)Therefore, when changing the value, be sure to check the status of usage to
confirm that not so many solid images in color have been output, and do not set a large
value at once.
For the user who output a large volume of solid images in color, do not use this service
mode.In summer, volume of waste toner tends to increase. Be careful not to increase
the value too much before summer.
F-2-102
T-2-39
