EA1-TCL-M Hardware User Manual, 1st Ed., 12/09
1–10
Chapter 1: Getting Started
1
®
Enclosure Clearances
A 1.2” [30mm] minimum clearance is required inside an enclosure for proper ventilation of
the
C-more
Micro-Graphic panel.
Enclosure
Enclosure
1.2
[30.0]
1.5
[38.1]
1.2
[30.0]
2
[50.8]
*
*
* Additional clearance for cable bend radius typically 1/2” to 1”
EA1-T6CL with
EA-2CBL
NOTE:
Cable connectors are typically longer than 1.2” (30mm). Therefore, in addition to ventilation
requirements, clearance must account for the connector and the cable bend radius.
Enclosure
1.2
[30.0]
Enclosure
1.2
[30.0]
1.2
[30.0]
NPUT:12 2 V 5W C as 2
S D
7M 7
Da e od * **
R0
MADE N CH NA
EA - 6C + e al umb r
MODEL EA1-T6CL
ND CON EQ.
8
1
15
9
Enclosure
1.2
[30.0]
Enclosure
units: inches [mm]
1.2
[30.0]
1.2
[30.0]
1.2
[30.0]
EA1-T6CL
Rear View
EA1-T6CL with
EA-MG6-BZ2(P)
EA1-T6CL
EA1-T6CL with
EA-ADAPTR-4
EA1-T6CL with
USB programming
cable
NOTE:
Additional clearance inside the enclosure is required when connecting to the 15-pin serial
communications port (Port2) unless the 90 EA-ADPTR-4 is used.
Содержание EA1-TCL-M
