Setting – Touch/Key Beep
With
Touch/Key
Beep
highlighted,
press ENT [F5] to
show the current
value for the internal
beeper. The default
is
ON
. The UP [F3]
and DWN [F4]
function keys can be
used to toggle
between the ON
and OFF state for
the beeper (enable
or disable). Use the
APL [F5] function
key to apply the
selection.
NOTE:
Loading a project to the panel will override whatever selection is choosen for the beeper from the
System Setup Screens’ Beep on/off selection screen. The Beep on/off choice can be changed through the
System Setup Screens
after
a project is loaded.
NOTE:
When the panel is powered through Port1 from a connected PC, the screen brightness is diminished
because the panel is running in
Low-Power Mode
. Connect an external 12-24 VDC power source when the
panel is installed in its application for full brightness.
ENT
SETTING
1 Brightness >
2 Touch/Key Beep >
3 Calibration >
4 Clear User Memory
5 Reset to Factory Def
6 Hourglass >
7 Rotation >
BAK
UP
DWN
ENT
NXT
BAK
UP
DWN
APL
ENT
TOUCH KEY / BEEP
Current Value
Enable
®
5
Chapter 5: System Setup Screens
5–8
EA1-TCL-M Hardware User Manual, 1st Ed., 12/09
Содержание EA1-TCL-M
