C-MORE EA1-TCL-M, Руководство пользователя по оборудованию

Страница: 142 / 179

C-more Micro-Graphic Panel Error Code Table
The following table includes all of the error codes and error messages that the panel will display
if the listed cause is detected. All of these errors involve problems that could result with the
panel communicating with the connected PLC. Be aware that not all of the panel errors are used
with each type of PLC that can be connected to the panel.
C-more Micro-Graphic Panel Error Code Table continues on the next page.
C-more Micro-Graphic Panel Error Table
Error Code Error Message Cause
P001 PLC Com Time Out A timeout occurred after sending a request to the PLC.
P002 NAK Received
A negative acknowledgement (NAK) control code has been generated during a read/write
request.
P003 EOT Received An end of transmission has been sent by PLC in response to a read/write/setbit request.
P004 STX is Not Found A Start of Text (STX) control code was not found in the data packet received from the PLC.
P005 ETX/ETB NotFound
Neither an End of Text (ETX) nor an End of Transmission Block (ETB) control code was found in
the data packet received from the PLC.
P006 LRC Not Match
There was an incorrect Longitudinal Redundancy Check (LRC) control code in the
communications packet received from the PLC. This is an indication that the data in the packet is
corrupted.
P007 CRC Not Match
There was an incorrect Cyclic Redundancy Check (CRC) control code in the communications
packet received from the PLC. This is an indication that the data in the packet is corrupted.
P008 Address NotMatch The address value returned in the data packet from the PLC is incorrect.
P009 Re.INV.FUN.Code The function code returned in the data packet from the PLC is incorrect.
P010 DataSizeNotMatch There are an incorrect number of bytes found in the data packet returned from the PLC.
P011 INV.Val.FUN.Code There is an invalid value in the function code.
P012 INVALID COMMAND There was an invalid command sent to the PLC that wasn’t recognized by the PLC.
P013 ENQ Received
If the data packet does not include a negative acknowledgement (NAK - 0x15 value) in the defined
packet field, then an enquiry (ENQ) control code error will be displayed.
P014 TransID NotMatch
This error will be displayed if after checking the Transaction ID Byte in the data packet, there is
no match to what was requested.
P015 Device Not Found A PLC device designated as Device could not be found.
P016 DataByte Com.Err The data part of the packet received contains 0 bytes of data.
P017 Out of Add.Range The touch panel requested a file number larger than 255.
P019 Parity Error Parity error occurred.
P021 PLC# Not Match PLC Number does not match
P023 Not Connected Cable not connected properly
P024 No Other Dev. Cannot detect other devices
P025 PollingListErr. Panel not in polling list
P028 No Response PLC failed to Respond: %PLC Node#%??
®
EA1-TCL-M Hardware User Manual, 1st Ed., 12/09
A
Appendix A: Panel & PLC Error Code Tables
A–3