C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
56
NA
– Sub-ID
Choose
Typical
for normal operation or select one of the custom created files from the list when
using multiple beacon satellite search. User must depress Restore Defaults button to use the
selected option and allow features of that selection to propagate to the beam configuration
section. This is extremely important when using the custom files.
2
– Modem Communication Interface
COM
–
Console Port Interface
TCP
–
TCP Interface
HTTP
–
HTTP Interface
UDP
–
User Datagram Protocol
AMIP
–
IP based Protocol that facilitates exchange of information between ACU and
Modem
3
– Modem Delay Time
This allows users to delay Controller communication to allow slower modems to catch up. The default
setting is 0
– 1s user has option for a 10s delay.
4
– Automatic TX Disable
The controller will automatically disable the transmitter if a reset is done to the modem or controller during
transmission and communication between the controller and modem is re-established. The action on the
TX disable occurs only after the communication between modem and controlled is restored. Default
setting is Y.
Y
– (Yes) Disable TX when power is restored after modem is reset.
N
– (No)
DO NOT
disable TX after modem is reset and power is restored.
5
– Enable iDirect Broadcast
This allows iDirect users with broadcast configured modems, to lock onto a DVB carrier, and
enable the transmitter in the iDirect modem automatically after peaking.
D
– Disabled
E
– Enabled
5
– Disable ACP (Hughes Ku)
Allows automatic cross pol to be performed. This is available for Hughes Ku service only.
Y
– (Yes) Disable Automatic cross-pol
N
– (No)
DO NOT
Disable Automatic cross-pol
6 - Dual Beam Search (iDirect Only)
The feature is for Dual coverage iDirect KU band, satellite search will be based on beam ID of
the dual beam and not the target satellite longitude, if the search on the first beam fails it will
automatically switch to the next beam. The search will remain in an endless loop until signal is
acquired.
Dual Beam Search option is valid only when “Read Carrier From Modem” is enabled.
Y
– Enabled
N
– Disabled
