C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
46
7.10.
CONF
This Menu will allow the user to select and set the configuration of the iNetVu
®
System as well
as the Reference satellite option. The target and the reference satellite(s) can be selected and
set from the pre-configured list. A description of each menu and their purpose is outlined below.
This section explains the different options of the configuration (CONF) menu, and what each
component means.
A step-by-step procedure of how to configure the system is explained in the
corresponding Service Provider Based User Manuals. Please refer to the service manual
quick start you are using with the 7710 Controller.
******** Password must be entered before accessing CONF menu and submenus. *********
Fig. 35:
Configuration Menu
SAT
Allows the user to configure the Target satellite, to also enable and
configure the Reference satellite.
MDM
Allows the user to configure the Modem parameters such as transmit
and receive polarization, as well as frequency and symbol rate (if
required).
EL
(Elevation) Allows configuration of the elevation offset.
AZ
(Azimuth) Allows configuration of the compass offset.
PL
Polarization) Allows configuration of the polarization zero, skew
adjustment, stow limit, polarization offset, speed, and current limits.
GP
(GPS and Compass) Configuration of GPS coordinates and Compass
parameters.
MT
Contains configuration of the platform type, platform version and serial
number.
CC
Contains controller configuration feature information such, Console Port
Configuration, DHCP Server, Motion Detection, Unattended Operation,
Inclined Orbit etc...
PW
Contains the password information. The user may change the password
in this screen.
SG
(Gateway and Subnet) Allows for the configuration of the controller
subnet IP address, as well as the controller gateway IP address.
IP
Configuration screen of the controller IP address, and the VSAT
modem’s IP address.
SR
The user may configure the service type, as well as the interface used to
establish communication between the controller and modem (telnet,
console, etc.) Ka services (HN_KA) will have the ability to change Beam
ID.
SAT MDM EL AZ PL GP
MT CC PW SG IP SR