Bticino D45, Техническое руководство

Страница: 12 / 156

SONORA - CARATTERISTICHE GENERALI
10
VIDEO DOOR ENTRY SYSTEM - GENERAL FEATURES
D45
The data given for the settings in the above table is only for
reference . In actual situations, some deviation may occur .
Therefore, we need to adjust the settings according to the
actual image requirements during installation .
Entrance panel functions overview
conFigure the ep parameters
The configuration parameters for the EP can be set either
through Item 5 in the function settings under the LCD
interface, or by means of the configurator . The latter is of
high priority, but it will need repowering each time the
resistance is replaced, as can be shown in the following
diagram:
NN refers to the EP address, #FF refers to the floor number
and #II refers to the maximum number of rooms in each
floor .
N
(Tens Place) N
(Units Place) #F
(Tens Place) #F
(Units place) #I
(Tens Place) #I
(Units Place)
Photosensitive function
When natural light falls below a certain degree, the stand-by
light compensation LED tube will come on to compensate for
the light . So even in dim light, users will be able to perform
the necessary . With the light compensation function the
visitors can be identified at a distance of up to 400 mm .
Volume adjustment
MIC: to adjust the output level of the microphone .
SPK: to adjust the volume of the speakers .
When used as (Backbone EP or main EP), it can download
the address book using the computer .
Online update of programs
It can download or update the software through the ISP
port, no need to open the cover .
Points to consider when adjusting the camera:
When adjusting the head up or down, the angle can’t be too
wide, or vignetting may occur .
Points to consider when installing the electric door lock
release of the entrance panel:
The electric door lock released controlled directly by the
entrance panel is a positive door lock release powered at
DC 12 V, with a control power source of ≤1 A . For other lock
types, door lock release item 323015 must be used .
n
Adjust the volume of the loudspeakers
n
Adjust the volume of the microphone
n
Anti-removal alarm open &close function
n
Camera Socket
n
Adjustment switch for video gains and to adjust the video
signals up and down
n
Setting pushbutton
n
Signal interface of door lock status
n
Connect the power or the door lock release
n
EP address configurator
n
Connect with CAT5 cable line to the system
The entrance panel has two video compensation gears . By
setting the different V-GAIN gears , we can adapt the video
signal output from the entrance panel to the different
transmission distances . Directions for the setting: On for
moving up and Off for moving down .
1 2
on
oFF
dip swiTch seTTing insTrucTion
For b/w and colour
insTallaTion
Distance 1 2
0 – 300 m OFF OFF
300 -700 m ON OFF
700 – 1000 m ON ON
N N #F #F #I #I